Section 9 - Chipping
|

The Short Game

90 min DVD
The Swing

90 min DVD
From Beginner
to Winner

David Leadbetter |
|
|
|
When
chipping there should be two styles of shots that you can use
when required. The first style is similar to putting where there
is no wrist action and mostly club head speed is developed
through the arm swing.
The second style is where there is a breaking
action with the wrists in the backswing and an un cocking in the
downswing and then a hold off of the release on the through
swing. This chipping style is known as a break and block
method. Generally when more distance and elevation is required
for the shot, the break and block style is going to be used. So,
particularly when using a lofted club this style is effective.
|
|
|
|
|
 |
 |
 |
| Ball position
back, hands in front |
maintain Y
between arms and shaft |
match follow
through length |
|
|
For a normal chip and run style shot, any club
can be used from a 3 wood or 3 iron through to sand iron.
Normally, the ball is positioned further back in
the stance to promote a bit of shaft lean forward with the hands
slightly ahead of the ball. Your grip should be down shorter on
the club which will encourage standing a little bit closer to
the ball. A little bit more weight on the left side will
encourage a slight downward blow with this style of shot.
The stance alignment is normally a little more
open than usual which will help to lessen lower half movement.
There will appear to be a “Y” formed between the
arms and the club shaft at address. This relationship should be
maintained during the shot which will ensure very little wrist
action.
|
 |
 |
 |

SAM PuttLab


Swing Analysis
CLUBFACE
ASSISTANT™


Training System
|
|
Grip down and stand closer ... |
...
mainly just arms ... |
...
swing club along target line. |
|
|
A short back swing and a long follow through or
a long back swing or short follow through can be employed but in
order to help develop a feel for distance required in the short
game it is recommended that you try to match up the backswing
and through swing when using the arm type chipping action, for
chip and run style shots.
The club head end of the shaft should still
point along the target line in the backswing, then back down
along the target line in the down and through swings.
The clubface should also appear to open in the
backswing and appear to close in the through swing.
The grip should be the same as normal for these
shots, with the exception of gripping lower down on the club and
the clubface should be square.
|
 |
 |
 |
|
Weight towards target |
break and block style |
left arm and shaft straight line |

PERFECTPLANE
Heavyiron™

Correct your
golf swing! |
|
|
The break and block method of chipping normally
will be used when some more distance and height is required for
the shot and when the club needs to be swung back a little bit
further. So you would use a normal wrist cock in the back swing.
If the club head reaches hip height, a little
bit of wrist should be employed. On the downswing the wrists
are uncocked, then on the through swing there’s no re cock, so
the left arm and club shaft remain in a straight line at the
conclusion of the swing.
Variations in ball position will alter the
trajectory of the shot so if you are required to hit a lower
shot then the ball should be further back towards the right foot
with a little bit of shaft lean forward and with the hand in
front of the ball. For a higher shot the ball position can be
more forward in the stance with the body more behind the ball.
|
 |
 |
 |
|
Keep it simple ... |
...
similar to putting ... |
...
maintain angles. |
|
|
|
|
Top | NEXT - Section 10 -
Pitching |
|
|
|
|